rbfly2

The RB-Fly was developed, based on DJI Developer SDK and rebotnix Transmitter hardware Solutions.

RB-Fly is a sender and transceiver with low latency and the lowest delay <1ms. With R-Bus, the multicast version of RB-Fly you can stream the live signal from any DJI UAV that support live-feeds and HDMI. frame accurate to a maximum of 60 Monitors at the same time. The RB-Fly System stays in perfect sync when you use the DJI iOS Application and the RB-Fly Hardare.

RB-FLY Specification RB-Fly Single

  • Sender Supports up to 720p60 and 1080p60 HDMI 1.4 input, Encoding
  • Latency <1 ms for the wireless transport
  • Supports one Receiver (included) up to 1080p60 decoding
  • Uses rebotnix R-Bus and Beamforming in 5GHZ
  • No interruption of DJI 2.4 GHZ Signals at all
  • Maximal output is 25 Milliwatts
  • Range of RB-Fly is maximal 20 Meters from a DJI Remote control
  • Power Input of Transmitter allows 7-17 Volts
  • Power Input of Receiver allows 7-17 Volts
  • No Modification on the UAV is required
  • FCC-ID & CE Certification

RB-FLY Specification RB-Fly Multicast

  • Sender Supports up to 720p60 and 1080p60 HDMI 1.4 input, Encoding
  • Supports up 60 RB-Fly Receiver (included in one device) up to 1080p60 decoding
  • Optional Multi Receivers
  • Uses rebotnix R-Bus and Beamforming in 5 GHZ Frequency Spectrum
  • No interruption of DJI 2.4 GHZ Signals at all
  • Maximal output is 50 Milliwatts
  • Range of RB-Fly is maximal 50 Meters from a DJI Remote control
  • Power Input of Transmitter allows 7-17 Volts
  • Power Input of Receiver allows 7-17 Volts
  • No Modification on the UAV is required
  • FCC-ID & CE Certification

 

image_pdfimage_print
Email this to someonePin on PinterestBuffer this pageShare on FacebookShare on Google+Tweet about this on TwitterShare on LinkedIn

Leave a Reply

Your email address will not be published. Required fields are marked *